6
Ex.1 Exposure time = setting value XYY
16
to obtain 1/125 second (= 8000μsecond).
()()
16
16
16
16
12
2C7XYY
C7
9
100
7
9
100
1
10
8000
YY
2
18000X
=∴
=
⎟
⎠
⎞
⎜
⎝
⎛
×=
⎟
⎟
⎠
⎞
⎜
⎜
⎝
⎛
×
⎟
⎠
⎞
⎜
⎝
⎛
−=
=
=
+
int
int
logint
Ex.2 Setting value 25D
16
that produces 1/234.22 second exposure time.
[sec]
sec][
)(
234.22
1
4269.53
9
100
5D
110
16
16
2
=
=
×+×=
+
µ
1
edShutterSpe
(4) CONFIGURATION : Setting of CameraLink configuration
BASE (Factory setting) : Connection is switched to Base configuration.
MEDIUM : Connection is switched to Medium configuration.
(5) DATA BIT : Setting of output bit depth
8bit (Factory setting) : Image is outputted by 8 bit.
10bit : Image is outputted by 10 bit.
12bit : Image is outputted by 12 bit.
(6) VD/FVAL : Setting of vertical sync signal
VD : Output VD.
FVAL (Factory setting) : Output FVAL.
(7) HD/LVAL : Setting of horizontal sync signal
HD : Output HD.
LVAL (Factory setting) : Output LVAL.
LVAL2 : Output LVAL2 and horizontal pixel is set to 1224 (multiple of 8) clocks.
(8) GAIN : Setting of electrical sensitivity
0 (Factory setting) to 18dB : Set from 0 to 18dB in 504 steps (for KP-F500PCL/SCL).
0 (Factory setting) to 12dB : Set from 0 to 12dB in 336 steps (for KP-FR500PCL/SCL).
(9) BLACK LEVEL : Adjust offset level
0 (Factory setting) to 63 : Set in 64 steps.
(10) VERTICAL 2 PIXEL ADDITION : Setting of vertical two pixel addition *This function is only for KP-F500PCL/SCL.
OFF (Factory setting) : Not perform vertical two pixel addition.
ON : Perform vertical two pixels addition and frame rate is increased about 2 times.
(11) PARTIAL SCAN : Setting about partial scan
-MODE- : Select of mode
OFF (Factory setting) : Not perform partial scan.
ON : Perform partial scan.
-START- : Start position of partial scan
1 (Factory setting) to 2058: Scan is started from the line set up in 1 to 2058.
-WIDTH- : Width of partial scan
1 to 2058 (Factory setting): Scan is performed number of line set up in 1 to 2058 is scanned.
* When using partial scan, please make sum total of START and WIDH into 2059 or less.
* When using partial scan, please use FVAL.
