User’s Guide 23
Presenting from a Networked Computer
6. For an Ad Hoc connection, set the following properties:
■ Set the Authentication Mode to Ad Hoc.
■ Match the Desired SSID and WEP Encryption to the settings on the projector.
■ If a channel setting is available, set the channel to Auto.
For an Infrastructure connection, set the following properties:
■ Set the Authentication Mode to Infrastructure.
■ Match the Desired SSID and WEP Encryption to the access point settings as
specified by the network administrator.
■ If a channel setting is available, set the channel to Auto.
7. Click OK.
8. Right-click Wireless Network Connection again, and click Properties.
9. Double-click TCP/IP. For each type of connection, use the following values:
■ For an Ad Hoc connection, set the following properties:
❏ Select Obtain an auto IP address.
❏ Select Obtain DNS server address automatically.
■ For an Infrastructure connection, check with your system administrator
to obtain the correct settings.
Showing Presentations
This section describes how to show presentations on a computer.
■ “To start a presentation” on page 24
■ “To stop showing your presentation” on page 25
■ “To include other presenters” on page 26
■ “To disconnect and free the projector” on page 27
