Glass door
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass door.
Do not use any abrasive powders.
Door gasket
The vinyl gasket may be cleaned with mild
soap and water, a baking soda solution or
a mild scouring powder. Rinse well.
After cleaning the door gasket, apply a
thin layer of paraffin wax or petroleum
jelly to the door gasket at the hinge side.
This helps keep the gasket from sticking
and bending out of shape.
Light bulb
replacement
Unplug the beverage center before
replacing the light bulb.
To remove the light shield, push in the tab
on the left side of the shield and lower it.
Replace with a 15 watt appliance bulb.
In the event
of a power
failure
If the power fails, open the door as
infrequently as possible to maintain
the temperature.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Care and Cleaning
Beverage Center
Condenser
Be sure that nothing obstructs the
required air flow openings in the front
of the cabinet. For best performance,
brush or vacuum lint and dirt from the
condenser once a year.
Remove the cover from the bottom rear of
the beverage center to access the
condenser. Remove the three screws from
the top of the cover and bend the sides of
the cover slightly inward to release the tabs
on each side of the cover.
When replacing, feed the power cord
through the hole on the bottom left of
the cover.
Unplug the beverage center before cleaning.
Interior
Wash the inside with mild soap and water
or baking soda and water.
Do not use an abrasive powder, solvent,
polish cleaner or undiluted detergent.
Cabinet
The painted cabinet can be washed with
mild soap and water. Rinse thoroughly
with clear water. Never use abrasive
scouring powders.
Screws
Tabs
11
