m
Questiom?
.~.
UseThis Problem Solver
-
PROBLEM
POSSIBLE CAUSE AND REMEDY
OVEN
WILLN~
G
A fuse in your home maybe blown or the circuit breaker tripped. Replace fuse or reset
COME ON
circuit breaker.
●
Unplug your microwave oven, then plug it back in.
●
Make
sure 3-prong plug on oven is fully inserted into wall receptacle.
CONTROL PANEL
. Door not securely closed.
LIGHTED, YET OVEN
. START pad must be touched after entering cooking selection.
WILL
N~
START
●
Another selection entered already in oven and CLEAR/OFF pad
not touched to cancel it.
●
Make
sure
you
have entered cooking time after touching TIME COOK I & II pad.
*
CLEAR/OFF pad was touched accidentally. Reset cooking program and touch
START pad.
. Make sure you have entered a temperature afier touching TEMP COOK/HOLD pad.
●
Make sure you entered a code number
atir
touching AUTO COOK,
AU~
ROAST,
AU~
DEFROST or
AU~
REHEAT pads.
FOODS ARE
E~HER
●
Cooking times may vary because of starting food
temperatum,
food density or amount of
OVERCOOKED OR
fds
in oven. Touch TIME COOK I &
H
pad and additiond cooking time for completion.
UNDERCOOKED
●
Incorrect power level entered. Check cookbook for recommended power level.
. Dish was not rotated, turned or stirred. Some dishes require specific instructions.
Check cookbook or recipe for instructions.
. Too many dishes in oven at same time. Cooking time must be increased when cooking
more than one food item. Check cookbook time recommendations.
G
Dish not covered as directed when
using Auto Cook function.
●
Previous microwaving left humidity or moisture in oven, thus lessening the cooking
time in Auto Cook function.
s
Certain vegetables need a standing time after using Auto Cook. Check Automatic
Cooking Control Guide.
. Probe not inserted properly into meat or dish when using Temp Cook/Hold or Auto
Roast functions, Check cookbook for specific instructions.
“PRObE”
APPEARS
●
Probe has been forgotten or not seated properly in oven wall when using Temp
ON DISPLAY
Cook/Hold or Auto Roast.
“Error” APPEARS
.
During Auto Cook or Auto Reheat progmrn, the door was opened before steam could
ON DISPLAY
be detected.
All these things are normal with your microwave oven:
●
Steam or vapor escaping from
●
Dimming oven light and change
c
Some TV-Radio interference
around the door.
in blower sound may occur while
might be noticed while using
your
●
Light reflection around door or
operating at power levels other
microwave oven. It’s similar to the
outer case.
than high.
interference caused by other small
●
Dull thumping sound while oven
appliances and does not indicate a
is operating.
problem with your oven.
Ifyouneed
more help... call,
toll
free: GE Answer Center” /800.626.2000 / consumer information service
30
