8
Press the battery
release button on the
end of the mouse, then
remove the battery
pack and discard the
plastic insulator tab.
To install and charge the mouse battery pack
1
Before using the wireless mouse and keyboard, install
the batteries into both devices, connect the power
adapter to the mouse charging cradle, charge the mouse
for 9 hours before using, and synchronize the mouse and
keyboard with the radio frequency (RF) receiver on your
Family Media Center.
Setting up and synchronizing the
wireless keyboard and mouse
Insert the battery
pack back into
the battery
compartment.
2
Place the mouse in the charging cradle. The cradle’s
LED indicator light,
located at the bottom of
the cradle, turns solid
green and the mouse
LED indicator will faintly
flash green while the
batteries are charging.
The mouse LED
indicator lights
continuously when it is fully charged and ready
to use.
4
Connect the power
adapter to the mouse
charging cradle, then
plug the power adapter
into the power outlet.
3
Tip:
To conserve power, the mouse enters a “sleep mode” when it is left
on and not used for more than 24 hours. Click any mouse button to
wake the mouse from “sleep mode.”
Tip:
When the battery drops to 20% of its full charge, the mouse LED
indicator blinks intermittently while in use. To optimize the NiMH
battery, recharge it at the end of each day’s use.
Tip:
If you do not need a fully charged battery for extended use, you can
remove the mouse from the charging cradle at anytime. You do not
need to wait for the mouse’s LED indicator light to stop flashing.
