ASC/ASCQ M2488 PRODUCT GUIDE
B-2 CG00000-011503 REV. A April 1997
4 44 00 Hardware error 1
5 1A 00 Parameter list length error 1
20 00 Invalid command operation code 1
21 01 Invalid medium changer element address 1
24 00 Invalid field in CDB 1
25 00 Logical unit not supported 1
26 00 Invalid field in parameter list 1
30 02 Incompatible format 8
3B 0D Destination medium changer element full 1
3B 0E No cartridge or magazine at specified medium changer source element position 1
3B 8F First destination medium changer element empty 1
3B 90 Second destination medium changer element full 1
3B 91 Second destination medium changer element empty 1
3B 92 Medium changer transport element full 1
3B 93 Medium changer element is not accessible 1
3B 94 Drive is full, operation cannot be performed 1
3D 00 Invalid bits in IDENTIFY message 1
6 28 00 Not ready to ready transition (Priority 2) 7
29 00 Power on, reset, or BUS DEVICE RESET occurred (Priority 1) 7
2A 01 Mode parameters changed (Priority 5) 7
33 00 Tape length error (Priority 3) 7
3F 01 Microcode has been changed (Priority 4) 7
7 27 00 Write protected 5,4
8 00 05 Tape void 1
30 01 Cannot read medium - unknown format 1
B 43 00 Message reject error 1
44 00 Internal target failure 4
45 00 No initiator response to reselection 1
47 00 SCSI parity error 1
48 00
Active SCSI command aborted due to an Initiator detected error message being re-
ceived
1
49 00 Invalid message error 1
4B 00 SPC transfer offset error or transfer period error 4
4E 00 Overlapped commands attempted 1
D 00 02 End-of-Medium detected 1
Table B-2. Action Advised Codes
ADVISED
ACTION CODE
DESCRIPTION
1 Treat the error as a permanent error.
2 Execute Dynamic Device Reconfiguration (DDR).
3 Continue processing.
Table B-1. ASC and ASCQ Description (by Sense Key) (Continued)
SENSE
KEY
ASC/ASCQ DESCRIPTION
ADVISED
ACTION
