Connecting Video Equipment - 29
In the case of component (color differential*) image signals
· Connect the projector’s Computer 2-BNC port to the video equipment with the component
image cable (available on the open market) so that the following table is supported.
· Connect the S-Audio/Audio 2 port with the RCA audio cable supplied (red/white) to output
sound from the projector's speakers.
Point
· A conversion connector (available on the open market) is required on the projector's BNC
port when a component image cable is connected. Align the connector on the video side
with the port on the user’s video equipment.
· Set the BNC parameter to [YCbCr] when the connection has been established. (see
page 59)
Video equipment R-Y(Cr) Y B-Y(Cb)
Projector R/Cr/Pr G/Y B/Cb/Pb
R/Cr/Pr port
G/Y port
B/Cb/Pb port
Audio port (White)
Audio port (Red)
To the R-Y (Cr) output port
To the Y output port
To the B-Y (Cb) output port
RCA audio cable (supplied with the projector)
Component images cable
(available on the open
market)
To the audio output port L
(white)
To the audio output port R
(red)
