Using the Document Camera 25
Turning the Lamps Off and On
Press the UPPER LAMP button on the remote control to turn off the
lamps. Press it again when you want to turn the lamps back on. There
will be a slight delay before the lamps turn back on.
Press the
BASE LAMP button on the remote control to turn the base
lamp on. Press it again to turn the base lamp off.
Adjusting the Image
Once you see your image, you may need to make certain adjustments:
■ To zoom or focus the image, see the next section
■ To double the size of the projected image, see page 27
■ If the image is too light or dark, see page 27
■ To increase the contrast between the image and its background,
see page 28
■ If the image has a color cast, see page 28
■ To rotate the image, see page 28
■ To reduce noise in the image, see page 28
■ To switch to a black and white image, see page 29
■ To freeze the image, see page 29
note
You can also press the LAMP
button on the document
camera to move through this
sequence: upper lamps off and
base lamp on, upper and base
lamps off, upper lamps on
and base lamp off.
PAUSE
LAMP
POSI/NEGA COLOR/B&W
IRIS
AF
2x
SET
RGB1 RGB2
NORMAL OPEN CLOSE
PRESET
CALL
TELE
ZOOM
MAIN
INPUT
WIDE
NEAR
FOCUS
FAR
UPPER BASE
SET
IMAGE
CALL
Turn the lamps
on and off
