Managing Projectors 81
■ To change the network addresses from the projector’s control
panel, press the right and left arrow buttons to select the part
of the address you want to enter, then use the up and down
arrow buttons to increase or decrease the numeric value.
When you finish changing an address in the network menu, press
the
Enter button (on the remote control) or the Auto/Enter
button (on the projector).
5. When you’re done, press
Esc to exit the menu system.
Using EMP Monitor
EMP Monitor lets you use a remote computer to manage your
projectors over a wired network. It lets you easily turn the projectors
on or off (together or individually), switch image sources, and check
their status.
Before using EMP Monitor, make sure you’ve installed the software
(available for Windows only) as described on page 114. The
computer you’re using to monitor the projector should already
be connected to your network.
Increase
or
decrease
the value
Select the part of the
address to change
note
If you want to monitor
projectors while they are in
standby mode, select
Standby Mode in the
Extended menu, then select
Network ON. See page 75.
