Epson EMP-7700 Manual

A SERVICE OF

next previous

Replacing the lamp - 87

Replacement method

1

Switch off the power supply, allow the projector to cool down, and then disconnect the

Power Cord.

The amount of time required for the projector to cool down will depend on the surround-

ing temperature.

2

Remove the lamp cover only after the lamp has cooled sufficiently.

· It will take at least 60 minutes for the lamp to cool sufficiently.

· Loosen the screw fixing the lamp cover in place with the screwdriver provided with the

replacement lamp. Pull the right-hand side of the lamp cover slightly forwards to release

the hook, slide it to the left and then remove the entire cover.

3

Withdraw the lamp.

Loosen the two screws holding the lamp in place, and then pull the lamp out towards you.

4

Attach a new lamp.

Align the direction, push the lamp in as far as it will go, and then secure it in place with

the two screws.

Avoid an open/close

angle exceeding 15

degrees when pulling the

cover forward. The use of

excessive force may result

in the clip on the hook

bending.