List of Functions
39
*2 When the mail notification function is set to "On" and the projector enters an abnormal/warning state, the following mail is sent.
Subject: EPSON Projector
First line: The projector name of the projector where the abnormality occurs
Second line: The IP address set for the projector where the abnormality occurs
Third line and on: Details of the abnormality
The details of the abnormality are described one by one, one line at a time. The following table explains the details shown in the message.
For details on dealing with abnormalities/warnings, see "Reading the Indicators" (s p.44).
Message Cause
Internal error An internal error has occurred.
Fan related error A fan error has occurred.
Sensor error A sensor error has occurred.
Lamp timer failure Lamp failure has occurred.
Lamp out A lamp error has occurred.
Lamp cover is open. The lamp cover is open.
Internal temperature error
A high temperature error has occurred.
(Overheating)
High-speed cooling in
progress
A high temperature warning has occurred.
Lamp replacement
notification
It is time to replace the lamp.
No-signal
No Signal
No image signal is being input to the
projector. Check the connection status for
the projector and that the power supply for
the connected equipment is turned on.
Air Filter Replace It is time to replace the air filter.
No Air Filter There is no air filter installed.
Low Air Flow A low air flow has occurred.
Air Flow Sensor Error An air flow sensor error has occurred.
Clean Air Filter It is time to clean the air filter.
Low Air Flow Error A low air flow error has occurred.
The (+) or (-) at the beginning of the sentence
(+): An error has occurred in the projector
(-): An error in the projector has been dealt with
Message Cause
