A SERVICE OF

logo

Submenu Function
Search Access
Point
When Connection Mode is set to Advanced, you can search for
surrounding access points, and select the SSID to connect from
those access points. Depending on the access point settings, they
may not be displayed in the list. You must set security separately.
IP Settings
(This can only be set if Connection Mode is set to Advanced.)
You can make network settings.
DHCP: Set to On to configure the network using
DHCP
g
. If this
is set to On, you cannot set any more addresses.
IP Address: You can enter the
IP address
g
assigned to the
projector. You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can enter the
Subnet Mask
g
for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can enter the IP address for the
gateway
g
for the projector. You can enter a number from 0 to 255 in each
field of the address. However, the following gateway addresses
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the
SSID
g
from being displayed on the LAN Standby
screen, set this to Off.
IP Address Dis‐
play
To prevent the
IP address
g
from being displayed on the LAN
Standby screen, set this to Off.
Search access point screen
Detected access points are displayed in a list. You can detect up to 30
access points.
Submenu Function
Refresh
Searches for the access point again.
Indicates an access point that is being connected.
Indicates the access points where security is set.
If you select an access point where security has not been set, the
Wireless LAN menu is displayed.
If you select an access point where security has been set, the
Security menu is displayed. Select a type of security according to
the security settings for the access point.
List of Functions
131