b
Select the Display or Color LCD option, if necessary.
c
Click the Arrange or Arrangement tab.
d
Select Mirror Displays.
Related Links
• "Solutions When "No Signal" Message Appears" p.175
Solutions When "Not Supported" Message
Appears
If the message "Not supported" is displayed, try the following solutions:
• Make sure the correct input signal is selected on the projector's Signal
menu.
• Make sure the computer's display resolution does not exceed the
projector's resolution and frequency limits. If necessary, select a different
display resolution for your computer. (See your computer manual for
details.)
Related Links
• "Solving Image or Sound Problems" p.174
• "Input Signal Settings - Signal Menu" p.135
Solutions When Only a Partial Image Appears
If only a partial computer image appears, try the following solutions:
• Press the [Auto] button on the remote control to optimize the image
signal.
• Try adjusting the image position using the Position setting in the
projector's Signal menu.
• Press the [Aspect] button on the remote control to select a different
image aspect ratio.
• Change the Resolution setting in the projector's Signal menu according
to the signal for the connected equipment.
• If you zoomed into or out of the image using the [E-Zoom] buttons,
press the [Esc] button until the projector returns to a full display.
• Check your computer display settings to disable dual display and set the
resolution within the projector's limits. (See your computer manual for
details.)
• Check the resolution assigned to your presentation files to see if they
are created for a different resolution. (See your software help for
details.)
• Make sure you selected the correct projection mode. You can select
Front, Front/Ceiling, Rear, or Rear/Ceiling as the Projection setting in
the projector's Extended menu.
Related Links
• "Solving Image or Sound Problems" p.174
• "Input Signal Settings - Signal Menu" p.135
• "Projector Setup Settings - Extended Menu" p.139
• "Supported Monitor Display Resolutions" p.190
Solutions When the Image is not Rectangular
If the projected image is not evenly rectangular, try the following solutions:
• Place the projector directly in front of the center of the screen, facing it
squarely, if possible.
• If you adjusted the projector height using the projector feet, press the
keystone buttons on the projector to adjust the image shape.
• Turn on automatic keystone adjustment in the projector's Settings
menu.
s Settings > Keystone > H/V-Keystone > Auto H/V-Keystone
Solving Image or Sound Problems
176
