F
When you are done, press the [Esc] button to exit the
correction menu.
Since Keystone in the Configuration menu has been changed to
Quick Corner, pressing the [
], [ ], [ ], and [
] buttons
on the control panel displays the selection screen from which you
can select the corner, as shown in procedure 2. If you want to
perform H/V-Keystone when you press the [
], [ ], [ ],
and [
] buttons on the control panel, change Keystone from the
Configuration menu to H/V-Keystone.
q
• In the Settings menu - Keystone of the Configuration
menu, when you have set Auto H/V-Keystone to On,
the message "Do you want to perform Auto H/
V-Keystone correction?" is displayed when the projector
is moved. After you perform this function, the Keystone
setting in the Configuration menu changes from Quick
Corner to H/V-Keystone, after which pressing the
[
], [ ], [
], and [
] on the control panel
performs H/V-Keystone.
s p.56
• If the [Esc] button is held down for about two seconds
while correcting with Quick Corner, the following screen
is displayed.
Reset Quick Corner: Resets the result of Quick Corner cor-
rections.
Switch to H/V-Keystone: Switches the correction method
to H/V-Keystone.
s p.56
Correcting Distortions in the Projected Image Using Quick Corner (EB-1925W/1915 Only)
28
