iNSTRUCTiONS FOR SINGLE SUSPENSION BRACKET TRACTORS
STEP 1 : (SEE FIGURE 2)
Open parts bag labelled "A" and verify that all parts are
present.
NOTE: Place cardboard or a mat on work surface to prevent
scratching of parts removed from carton and tractor.
CAUTION! Muffler is hot! Allow engine to
cool down before proceeding with bumper
installation.
NOTE: Right hand (RH) and left hand (LH) are
determined from the operator's position while seated on
the tractor.
SHOWN FULL SiZE
PARTS BAG "A"
.... D
I/
I/
r-
"1 I
...... F
NOT SHOWN
FULL SIZE
FIGURE 2
STEP 2: (SEE FIGURE 3)
Remove hood from tractor using instructions in your
tractor owner's manual. Place hood on cardboard or
on a mat to protect paint.
Remove the browning shield from the front of the
tractor as shown.
IMPORTANT: Be sure to reattach the browning shield
after bumper is installed.
REF PART NO. QTY. DESCRIPTION
A 43350 2 Carriage Bolt, 3/8-16 x 1"
B 43062 2 Hex Bolt, 3/8-16 x 1-1/2"
C 44072 4 Whizlock Nut, 3/8"
D 44742 4 Plug
E 48866 2 Pivot Spacer
F 1643-60 2 Plastic Grip
REMOVE
FRONTSCREWS
REMOVE
BROWNING SHIELD
FIGURE 3
Catt1-866-576-8388formissingpartsorassemblyhelp 3
DO NOT RETURN TO STORE
