21
Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note
78-16856-01
Related Documentation
To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to
Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch Cisco IOS Software
Configuration Guide.
To understand the Catalyst operating system command-line interface and Catalyst operating system
command modes, refer to Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch
Configuration Guide.
Unless your switch is located in a fully trusted environment, we recommend that you configure the
module through a Telnet connection using Secure Shell (SSH) encryption.
You can session into the module from the switch console and configure the CSM-S. The session is a
Telnet interface through the Ethernet out-of-band channel (EOBC) of the switch backplane.
You can also make a Telnet connection into the module from a specified host and on a specific interface.
Telnet support for this host should be configured or enabled from the module console.
Console output is redirected to all active Telnet sessions. When no Telnet session is available, the output
is saved to a buffer. The buffer output can be subsequently examined when you make a Telnet connection
into the module.
Related Documentation
For more detailed installation and configuration information for the Content Switching Module with
SSL, refer to the following publications:
• Release Notes for the Catalyst 6500 Series Switch Content Switching Module with SSL
• Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note
• Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
• Regulatory Compliance and Safety Information for the Catalyst 6500 Series Switches
For more detailed installation and configuration information for SSL services, refer to the following
publications:
• Release Notes for Catalyst 6500 Series SSL Services Module Software Release 2.x
• Catalyst 6500 Series Switch SSL Services Module Installation and Verification Note
• Catalyst 6500 Series Switch SSL Services Module Command Reference
• Catalyst 6500 Series Switch SSL Services Module System Messages
Translated Safety Warnings
Warning
Invisible laser radiation present.
Statement 1016
Waarschuwing
Onzichtbare laserstraling aanwezig.
Varoitus
Näkymättömiä lasersäteitä.
Attention
Rayonnement laser actif mais invisible.
