11
Catalyst 6500 Series Switch Content Switching Module with SSL Installation Note
78-16856-01
Installing the CSM-S
Software Requirements
Caution The CSM-S release is not supported by the Catalyst operating system.
Table 4 lists the software versions for the CSM-S.
Software Compatibility
The minimum software version that is listed is the minimum release that is required to support the
CSM-S hardware with a given supervisor engine to perform basic CSM-S configuration.
The recommended version is the base version to support the new commands for a given CSM release.
Table 5 and Table 6 list the CSM-S software release compatibility.
Installing the CSM-S
These sections describe how to install the CSM-S:
• Preparing to Install the CSM-S, page 12
• Required Tools, page 12
• Installing and Removing the Module, page 12
Caution The WS-X6066-SLB-S-K9 Content Switching Module with SSL is not fabric enabled.
Table 4 CSM-S Software Requirements
CSM-S Software Release Software Part Number Hardware Catalyst Operating System Cisco IOS Release
2,1(1) SC6K-1.1-CSM-S WS-X6066-SLB-S-K9 Not Applicable Cisco IOS software
Release 12.2(18)SXD
Table 5 Cisco IOS Software on the Supervisor Engine 2 and MSFC 2
CSM-S Software Cisco IOS Software
2.1(1) 12.2(18)SXD or higher for the features new to CSM-S release 2.1(1).
Table 6 Catalyst Operating System on the Supervisor Engine and Cisco IOS Software on the MSFC
CSM-S Software Catalyst Operating System Software
2.1(1) The CSM-S is currently not supported by the Catalyst operating system.
