Configuration Wizards
Using the Dual WAN Wizard to Configure WAN Redundancy Settings
Cisco ISA500 Series Integrated Security Appliances Administration Guide 51
2
Using the Dual WAN Wizard to Configure WAN Redundancy
Settings
If you have two ISP links, a backup WAN is required so that you can provide
backup connectivity or load balancing. Use the Dual WAN Wizard to configure the
WAN redundancy settings. Refer to the following steps:
• Starting the Dual WAN Wizard, page 51
• Configuring a Configurable Port as a Secondary WAN Port, page 51
• Configuring the Primary WAN, page 52
• Configuring the Secondary WAN, page 52
• Configuring WAN Redundancy, page 52
• Configuring Network Failure Detection, page 53
• Viewing Configuration Summary, page 54
Starting the Dual WAN Wizard
STEP 1 Click Configuration Wizards > Dual WAN Wizard.
STEP 2 Click Next.
Configuring a Configurable Port as a Secondary WAN Port
STEP 3 On the Port Configuration page, specify a configurable port (from GE6 to GE10) as
the secondary WAN port. The physical port GE1 is reserved for the primary WAN
port.
STEP 4 After you are finished, click Next.
