Setting the User Bit
72
Setting the User Bit
The user bit display can be selected from the date or the time of
recording, or an identification code consisting of 8 characters in the
hexadecimal system. There are sixteen possible characters: the numbers
0 to 9 and the letters A to F.
1 Open the user bit [Type] submenu.
[¤ TC/UB Setup] > [User Bit] > [Type]
2 Select the desired user bit type and then press the joystick.
• Select [Setting] to set your own identification code, [Time] to use the time as user bit, or [Date] to use the
date as the user bit.
• If you selected [Time] or [Date], you do not need to perform the rest of the procedure. If you selected
[Setting], continue the procedure to set the identification code.
3 Select [Set] and then press the joystick.
• The user bit setting screen appears with an orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset] instead.
4 Push the joystick up/down to select the first character and then press the joystick to move to the
next digit.
• Change the rest of the digits in the same way.
• Press the CANCEL button to close the screen without setting the user bit.
5 Select [Set] and then press the joystick to close the screen.
NOTES
• User bit output: The user bit will be output along with the video output from the HDMI OUT terminal. In
mode, you can select the output mode with the [¤ TC/UB Setup] > [User Bit] > [Output Mode] setting.
When [Output Mode] is set to [Pulldown] and the frame rate is set to PF24 or 24P, the user bit will be
converted to 60i using the 2:3 pulldown method before it is output.
Operating modes:
[¤ TC/UB Setup]
[User Bit]
[Type]
[Setting]
