A SERVICE OF

logo

Installing the ESX
ESX-1320/ESX-1380 Installation Guide 3-15
Figure 3-10 Attaching the Strain-Relief Bracket
Rack Mounting the ESX
Proceed as follows to install the ESX into a 19-inch rack.
1. Remove and discard the four cover screws (two from each side)
located along the front edges of each side of the ESX.
2. Locate the four 6-32 x 3/8-inch flathead replacement cover screws in
the accessory kit. Using these screws, attach the rack mounting
brackets to each end of the ESX as shown in Figure 3-11.
Figure 3-11 Installing the Rack Mounting Brackets
NOTE
Do not remove the cover from the ESX. Complete any BRIM
installation or SIMM upgrades before installing the ESX in a
rack.
Screws (4)
Strain-Relief
Bracket
1574-12
7X 8X 9X 10X 11X 12X1X 2X 3X 4X 5X 6X
ESX-1320
COM 2 COM 1
DISPLAYRESET
MULTI PORT ETHERNET SWITCH
WITH
FDSE
AND
LANVIEW
®
PWR
CPU
RECEIVE
TRANSMIT
PORT
123456789101112
Screws (4)
Rack Mounting
Brackets (2)
1574-06
1X 2X 3X 4X 5X 6X
ESX-1320
COM 2 COM 1
DISPLAYRESET
MULTI PORT ETHERNET SWITCH
WITH FDSE
AND LANVIEW
®
PWR
CPU
RECEIVE
TRANSMIT
PORT
123456789101112
7X 8X 9X 10X 11X 12X