Printer-Applicator-System PAM 300040
11 Printer Info Display
Viewing the Printer Info Display
PAM 3000 offers a convenient option for retrieving and viewing information about the printer
configuration and occurred hardware problems without using setup mode or test print mode.
After switching on, or completing the system test or print jobs, the printer is in ONLINE mode.
Pressing the key will switch into OFFLINE mode where the display shows the status
information on ten different pages which are accessible by repeatedly pressing the key.
The printer info display can be exited by pressing the key (back into ONLINE mode) .
Definition of the Printer Info Display
Printer info
1: RS 232 / RTS/CTS
Fig. 11 a Printer info display 1
On the first page, the selected interface (default setting : RS232) and the handshake or
protocol (default setting : RTS/ CTS) will be shown.
Printer info
2: 9.600
Fig. 11 b Printer info display 2
The second page contains information about the fixed baud rate of the serial interface (default
setting : 9600).
Printer info
3: 2.58 / Aug 15 01
Fig. 11 c Printer info display 3
On the third page, the version and the date of the firmware are shown.
The example as shown in figure 11c represents the firmware version No. 2.58 as at Aug 15,
2001.
Printer info
4: 0000 / 2 / 5 / C
Fig. 11 d Printer info display 4
The fourth page of the info display contains coded information on the configuration of the
printer and the internal test results in the format "xxxx / y / z / C".
