Part No 360251 Form No F071206A
7
AE Owner’s Manual
PACKING CHECKLIST
Your Billy Goat is shipped from the factory in one carton, completely assembled except for the upper handle
assembly, and lift rod.
PUT OIL IN ENGINE BEFORE STARTING
ASSEMBLY
all safety instructions before assembling unit.
TAKE CAUTION
when removing the unit from the box.
1.
Unfold the upper handle (item 48) and slide handle lock loops (item 118) into place to secure the upper
handle to the lower handle (item 82 & 83).
1. BRIGGS Remove the bolts and nuts that are shipped in the upper handle. While holding the lock loops on the
handle use the bolts and nuts removed above to attach the upper handle to the hinge bracket on the lower handles
and tighten nut against the bracket. NOTE: DO NOT over tighten. The handle should be free to rotate for folding.
2. PIVOT the lift rod (item 46), insert the pin through the lift handle (item 52) then lock in place with lynch pin (item
47). Repeat same steps on other side.
3. FILL the water tank (item 2) to desired weight with water ONLY.
4. CHECK engine oil level and fill to proper level. Also check oil in gear reduction reservoir and fill if necessary. See
engine owner’s manual for type and amount of oil to use. Move the tine engagement lever to the down position, to
level engine during checking.
5. CONNECT spark plug wire. Set the engine stop switch to the ON position. You will use the stop switch on the
handle during operation.
Boxing Parts
Checklist
Owner’s Manual
AE 360251
Engine Manual Per
Model
Honda 4.0 HP
B&S 5.5 HP
PARTS BAG &
400972, Owner’s Manual P/N
360251, Declaration of Conformity P/N 360194.
52
46
82
118
83
48
2
47
FILL WITH
WATER ONLY!
