17
NOTE:
1. When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignition
circuits. When Diesel is selected, the ignition circuits will power up 10 seconds before the start circuit.
The intent of this feature is to allow the glow plug warming required by some diesel engines. If your
vehicle is a instant start diesel, it is not necessary to activate this feature.
NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and
be certain to connect the tach input wire.
2) The difference between selecting Starter Pole 5X or Starter Pole 3X, (Feature Ten), is considering the
time it takes from when the unit reaches the pre-set RPM to when the Starter Motor drops out. This
feature allows fine adjustments when you note a slight overcrank. If after programming tach, the unit
seems to hold the starter engaged slightly longer than necessary, select this feature to pole 3 X. If the
unit starts and the starter drops out properly, (NO OVERCRANK) no change is necessary.
To Program The Remote Start Selectable Features:
1. Start with the valet/program switch in the "Off" position.
2. Turn the ignition key to the On position.
3. Flip the valet/program switch On, Off, On, Off, On, then Off.
4. Immediately turn the ignition key Off then press transmitter button 2 for 1 second.
5. Immediately turn the ignition key back On.
6. Flip the valet/program switch On, Off, On, then Off. The siren will emit 2 short and 1 long chirp
verifying you are in the feature program mode.
7. Use button 1 on the transmitter to advance to the feature you want to change. EXAMPLE- If you
need to change selectable feature 3, press and release button 1 on the transmitter 3 times in
succession. The parking lights will flash, and the siren will chirp 3 times confirming that selected
feature 3 can be changed.
8. Use button 2 on the transmitter to change the selection of the programmable feature. If you are not
sure what the setting for any feature is, press button 2 one time, the parking lights will flash once or
twice indicating the features setting.
NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between
steps, or the programming mode will be terminated.
REMOTE START SELECTABLE FEATURES
RF Programmable Features:
LED Pattern
1 x Pause etc.
2 x Pause etc.
3 x Pause etc.
4 x Pause etc.
5 x Pause etc.
6 x Pause etc.
7 x Pause etc.
8 x Pause etc.
9 x Pause etc.
10 x Pause etc
Default
Off
10 Minutes
Steady
Tach
----------------
Off during crank
Off
---------------
Gasoline
Pole 5X
Park Lights Flashes 2 x
RF start chirp confirm on
15 minute run time
Parking lights flash
Tach operation
(No function)
Ignition 2 on during crank
Diagnostics on
(No function)
Diesel Engine
Starter Pole 3X
Park Lights Flash 1 x
RF start chirp confirm off
10 minute run time
Parking lights on steady
(No function)
(No function)
Ignition 2 off during crank
Diagnostics off
(No function)
Gasoline Engine
Starter Pole 5X
Feature Selection
First
Second
Third
Fourth
Fifth
Sixth
Seventh
Eighth
Nine
Ten
