A SERVICE OF

logo

! WARNING ! – RELIEF PROCEDURE
DO NOT EVER point the dispensing valve at another person.
DO NOT EVER attempt to stop material from the dispensing valve or a leaking connection with your hand
or body.
BEFORE EACH USE, check equipment for proper operation and to insure safety devices are in place and
working properly.
NEVER modify this equipment. Modification could cause equipment malfunction and result in serious
bodily injury.
When flushing the pump with solvents, ALWAYS hold a metal part of the dispensing valve firmly to the
side of a grounded metal pail and operate pump at the lowest possible fluid pressure to reduce the risk of
injury from splashing or static sparking.
WARNING: This pump can develop 7500 PSI working pressure at 120 PSI maximum incoming air
pressure. Be sure that all system equipment and accessories are rated to withstand the maximum working
pressure of this pump. NEVER exceed the maximum working pressure of the lowest rated component in the
system. IMPORTANT: “Whip” hoses for dispensing valve are fluid pressure rated at 4500 PIS. NEVER
exceed 90 PSI, air pressure to pump when using “whip” hoses.
WARNING: Water and even moist air can cause this pump to corrode. To aid in the prevention of this
corrosion, NEVER leave the pump filled with water or air. After normal flushing, flush the pump once more
with mineral spirits or an oil based solvent, relieve pressure and leave the mineral spirits in the pump. BE
SURE TO CORRECTLY FOLLOW THE PRESSURE RELIEF PROCEDURE.
PRESSURE RELIEF PROCEDURE
ALWAYS FOLLOW THIS PROCEDURE to reduce the risk of serious bodily injury, including splashing
into the eyes. After shutting off the pump; checking/servicing any part of the system; installing/cleaning or
changing any part of the system, ALWAYS follow this procedure:
1. Disconnect the air supply to the pump.
2. Aim the dispensing valve away from yourself and others.
3. Aim the dispensing valve into an appropriate container and open until all pressure is relieved.
If you believe that the dispensing valve or hose is completely clogged or that pressure in the pump has not
been fully relieved after following the above procedure, VERY SLOWLY loosen the hose end coupling to
relieve the pressure gradually and then loosen completely. Then proceed to clear the valve or hose.
WARNING: ALWAYS follow the Pressure Relief Procedure after shutting off the pump.
WARNING: ALWAYS follow the Pressure Relief Procedure when checking/servicing any part of the
system and when installing, cleaning or changing any part of the system.
INSPECTION INSTRUCTIONS
If you believe that you have overpressurized the equipment, or if your equipment requires adjustments or
repair, contact your Authorized Distributor or Service Center for inspection of the pump.
INSTALLATION
It is recommended that you use an air line filter/regulator/lubricator to remove
harmful dirt and moisture from the compressed air supply and to provide automatic lubrication to the
air motor. Blow-dry the lines and hoses with air before connecting them to the system..