Configuring PAD/ATPAD Ports 27
PAD Profile Table Record
PAD Profile Table Record
Introduction
The PAD Profile Table Record specifies the profile for a single PAD Port, in the local
node. Many other PAD ports can also use the same PAD Profile Table Record to
ensure that all PAD Ports have the same characteristics. You can configure up to 16
PAD profiles.
What You See In
This Record
Figure 7 shows how the PAD Profile Table Record and its configuration parameters
fit into the PathBuilder S200 series switch menu hierarchy.
Figure 7. PAD Profile Table Record
Before You Begin
Before you can configure parameters, you must log on to the local node’s control
terminal port. Refer to the
Configuration Basics Guide
for CTP procedures.
Entry Number
Profile Name
#1, PAD Recall
#2, Echo
#3, Data Forwarding Character
#4, Idle Timer Delay
#5, Device Flow Control
#6, Service Signals Control
#7, Break Signal Operation
#9, Padding After Carriage Return
#10, Line Folding
#12, PAD Data Restraint
#13, Linefeed Insertion After CR
#14, Padding After LF
#15, Editing
#16, Character Delete
#17, Line Delete
#18, Line Display
#19, Editing Type
#20, Echo Mask
#21, Parity Treatment
Node: Address:) Date: Time:
Menu: Configure Path: (Main.6)
Node
Port
•
•
•
PAD Profile Table
#22, Page Wait
#100, Break Character
#101, Echo Substitution Toggle Character
#102, Echo Substitution Character
#103, XON Character
#104, XOFF Character
#105, Control Signal (EIA-232-D) Data Restraint
#106, Network Parity
#107, Idle Disconnect Timer
#108, Disconnect Character
#109, Form Feed Padding
#110, Esc Forwarding Delay Handling
#111, Echo Control
#112, Dynamic Data Forwarding
#113, Hewlett-Packard Flow Control
#114, PAD Mode (Polled Async Only)
#115, Data Forwarding Criteria (Polled Async Only)
#116, Short Timer Duration (Polled Async Only)
#117, EIA Signalling Action (Polled Async Only)
#118, Message Assembly (Polled Async Only)
#119, DCD to Data Timer Duration
