Filter
Top Products
8
DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control
Monitor Display
BATTERY INSTALLATION
The console requires two "AA" batteries (not includ-
ed). Alkaline batteries are recommended. To install
batteries, open the battery cover as shown below.
Press the batteries into the battery compartment, with
the negative (Ð) ends of the batteries touching the
springs. Close the battery cover, push up on the tab,
and then push the tab forward as shown. Be sure that
the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.) If there is
a thin sheet of clear plastic on the console, remove it.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above) and
slide the clip onto your waistband.
Follow the steps on page 9 to operate the console.
CAUTION: Before operating the
console, read the following precautions.
¥ Do not stand on the walking belt when turn-
ing on the power.
¥ Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
¥ Adjust the speed in small increments.
¥ The training zones marked around the speed
control are general guidelines only. See
page 14 or more information.
¥ To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
Batteries
Battery Cover
Battery
Cover Tab