Filter
Top Products
MAINTENANCE AND TROUBLE-SHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please call our Customer Service Department toll-
free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).
PROBLEM: The power does not turn on
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged
into a properly grounded outlet (see page 7). Use only a single-outlet surge suppressor that is UL 1449 listed
as a transient voltage surge suppressor (TVSS). The surge suppressor must have a UL suppressed voltage
rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be
electrically rated for 120 volts AC and 15 amps. Important: The treadmill is not compatible with GFCI-
equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill frame near
the power cord. If the switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
PROBLEM: The power turns off during use
a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing above). If the
circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call our Customer Service Department, toll-free.
PROBLEM: The displays of the console do not function properly
a. Check the batteries in the console. If the batteries need to be replaced, see ÒBATTERY INSTALLATIONÓ on
page 8. Most problems are the result of drained batteries.
b. Remove the screws from the hood, and carefully remove the
hood. Locate the Reed Switch (76) and the Magnet (93) on the
left side of the Pulley (77). Turn the Pulley until the Magnet is
aligned with the Reed Switch. Make sure that there is a gap of
about 1/8Ó between the Magnet and the Reed Switch. If nec-
essary, loosen the Screw (17) and move the Reed Switch
slightly. Retighten the Screw. Re-attach the hood, and run the
treadmill for a few minutes to check for a correct speed reading.
Tripped
Reset
Tripped
Reset
c
45
44
33
Top
View
1/8Ó
50
12