Filter
Top Products
7
2
. With the help of another person, carefully lower the
Uprights (69) as shown. Note: It may be helpful to place
one foot on one of the Extension Legs [63] as you tip the
Uprights. Make sure that the Extension Legs remain
i
n the Uprights.
Attach each Extension Leg (63) with two 1” Tek Screws
(39) and a Round Base Pad (57) as shown. Attach the
l
ower Tek Screw, without the Round Base Pad, first.
Attach two more Round Base Pads (57) to the base of
the Uprights (69) with two 1” Tek Screws (39). Note: One
replacement Round Base Pad may be included. If a
Round Base Pad becomes worn and needs to be re-
placed, use the replacement Round Base Pad.
Attach the two Wheels (66) with two 2” Bolts (64) and
two Wheel Nuts (32) as shown. Do not overtighten the
Bolts.
The Wheels should be able to spin freely.
With the help of another person, carefully raise the
Uprights (69) to the vertical position.
39
69
63
39
57
63
57
57
39
64
6
6
32
69
2
3. Identify the Right Handrail (72), which has a large round
hole in the location shown. Route the Upright Wire (42)
through the hole in the Right Handrail. Press a Handrail
Cap (40) onto the lower end of the Right Handrail as
shown. Attach the upper end of the Right Handrail to the
right Upright (69) with a 2 1/2” Bolt (37). Be careful not to
pinch the Upright Wire. Firmly tighten the Bolt. Attach
the lower end of the Right Handrail and the Handrail Cap
with a 3/4” Tek Screw (58) and a Washer (38).
Attach the Left Handrail (71) in the same way. Note:
There is not an upright wire on the left side.
37
37
71
42
72
69
69
40
Large
Hole
3
58
58
38
64
66
32
57
39
40
38