Filter
Top Products
4. With the help of a second person, hold the Console Base
(12) and the Right Handrail (32) near the right Upright
(31) as shown. Feed the excess Wire Harness (28) into
the Handrail (32) and then insert it down the right Upright.
Next, insert the bracket on the Right Handrail into the
right Upright. Be careful not to pinch the Wire Harness.
5. Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22) only
a couple of turns into the upper end of the right Upright
(31) and the Right Handrail (32). Do not tighten the Bolt
yet.
Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22) only
a couple of turns into the lower end of the Right Handrail
(32) and the right Upright (31). Do not tighten the Bolt
yet.
6. Set the Console Base (12) on the Handrails (30, 32). Make
sure that the Wire Harness (28) is out of the way as you
loosely thread four 1 1/4Ó Screws (98) into the Handrails
and the Console Base. Next, push the Wire Harness
down the right Upright (31). It may be necessary to pull
the Wire Harness out the bottom of the right Upright.
Tighten all parts used in steps 3 and 5. Then, tighten
the 1 1/4Ó Screws (98) used in this step.
7. Remove the six Weight Rack Screws (97) from the right
Upright (31). Attach a Weight Rack (74) to the right
Upright with the Weight Rack Screws. Attach the other
Weight Rack to the left Upright (not shown) in the same
way.
Put the two 2-lb. Weights (20) on the upper hooks on the
Weight Racks (74), the 3-lb. Weights (19) on the center
hooks, and the 4-lb. Weights (17) on the lower hooks.
8. Remove the backing from the Wrench Clip (91). Press
the Wrench Clip onto the base of the right Upright (31) in
the indicated location. Press the Allen Wrench (90) into
the Wrench Clip.
9. Make sure that all parts are tightened before you use
the treadmill. To protect the floor or carpet, place a mat
under the treadmill.
28
Bracket
32
31
4
12
6
22
23
23
22
31
32
5
98
28
12
98
30
31
32
6
74
31
19
17
20
97
7
90
91
31
8