Filter
Top Products
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
13
14
1
76
46
96
Ties
47
6
46
10
21
6. Place the Console Base (46) on the Right Handrail (47)
and the Left Handrail (not shown). Attach the Console
Base with four 1 1/4” Screws (105) (only two Screws are
shown).
Do not tighten the Screws yet.
Insert the Wire Harness (21) through the two indicated
plastic ties on the Console Base (46). Next, insert the
Wire Harness up through the indicated opening in the
Console Base. Make sure that the Console Cover (96) is
securely attached to the Console Base.
Refer to the inset drawing. Look at the top of the Console
Base (46). Insert the Wire Harness (21) through the plas-
tic tie on top of the Console Base.
7. Hold the Console (10) near the Console Base (46). Touch
the Right Upright (62) to discharge any static. Find the 3-
wire connector on the end of the Wire Harness (21). Insert the
connector into the red socket beneath the console.
The con-
nector should slide easily into the socket and “snap”
into place.
If the connector does not slide easily and snap
into place, turn the connector and then insert it.
Insert the 5-wire connector into the black socket beneath
the console in the same way. Make sure that the connec-
tors and wires appear as shown in 7a.
Insert the excess Wire Harness down through the opening
in the Console Base. Refer to the inset drawing in step 6
above.
Securely tighten the plastic tie on top of the
Console Base to prevent the Wire Harness from slip-
ping.
Then, cut off the end of the plastic tie. Refer to draw-
ing 7b. Press the Book Rack (90) onto the Console Base
(46) in the location shown.
Set the Console (10) on the Console Base (46). Insert the ex-
cess Wire Harness (21) into the large hole in the side of the
Right Handrail (47).
Securely tighten the plastic ties on the
bottom of the Console Base to prevent the Wire Harness
from slipping. Then, cut off the ends of the plastic ties.
Attach the Console (10) to the Console Base (46) with two
1/2” Silver Screws (97) and four 3/4” Screws (13).
Start all
six Screws before tightening them; do not overtighten
the Screws.
7
8
21
21
Tie
46
105
62
97
13
13
47
Ties
3-Wire
7
21
46
90
7b
7a
8. Attach the Storage Latch (14) to the left Upright (76) with two
3/4” Screws (13). Be careful not to overtighten the Screws.
Lift the treadmill frame (see HOW TO FOLD THE TREAD-
MILL FOR STORAGE on page 12), but do not latch it.
Make sure that the frame is centered between the
Handrails (1, 47 [not shown]).
Firmly tighten all of the
bolts and screws used in assembly steps 3, 4, 5, and 6.
Then, lower the frame to the floor.
5-Wire