Filter
Top Products
66
5
14
9
9. Attach the Storage Latch (66) to the Left Upright (14)
with two 3/4” Screws (5).
10.Make sure that all parts used in assembly are prop-
erly tightened before you use the treadmill. Keep the
included allen wrench in a secure place. The allen
wrench is used to adjust the walking belt (see page 13).
To protect the floor or carpet, place a mat under the
treadmill.
87
53
10
5
5
5
8
8. Set the Console (11) in the Console Base (87). Cover
the Wire Harness (53) with the Wire Cover (10), and
route the Wire Harness out of the hole in the side of the
Wire Cover. Attach the Wire Cover to the back of the
Console Base with two 3/4” Screws (5). Make sure that
no wires are pinched before you attach the Console
to the Console Base.
Tighten four 3/4” Screws (5) into the Console Base (87)
and the Console (11). Do not overtighten the Screws.
7. Hold the Console (11) near the Console Base (87).
Touch the Right Handrail (94) to discharge any static.
Locate the two wires in the Wire Harness (53) that have
L-shaped connectors on the ends. Press the connectors
onto the two tabs on the switch shown in inset drawing
7a. Connect the other two wires in the Wire Harness to
the back of the Console (87) in the locations shown by
the arrows in drawing 7. If the connectors do not fit
together easily, rotate them and then connect them.
Securely tighten each plastic tie to prevent the Wire
Harness from slipping. Cut off the ends of the plastic
ties.
11
53
53
7
87
7a
Tabs
7
Ties
11
94
12
Hinges
87
6
6. Insert the Battery Cover (12) into the Console Base (87),
with the hinges in the position shown. The Battery Cover
should pivot down, away from the Console Base.