Filter
Top Products
6
4. If there are plastic ties in the brackets on the Left and
Right Handrails (4, 94), remove them. Hold the Right
Handrail near the Right Upright (62) as shown. Insert the
Wire Harness (53) up through the bracket on the
Handrail and out of the round hole in the side of the
Handrail. If necessary, use needlenose pliers to pull the
Wire Harness out of the hole. Be careful not to damage
the Wire Harness. Insert the brackets into the tops of
the Left and Right Uprights (14, 15).
Hand tighten four 1” Bolts (16) with Handrail Washers (7)
into the Uprights (14, 15) and the Handrails (4, 94).
7
53
15
7
14
Connectors
16
7
16
4
16
94
16
Bracket
4
86
Plastic Ties
86
94
4
53
87
5
5. Set the Console Base (87) on the Left and Right
Handrails (4, 94). Thread four 1 1/4” Screws (86) into the
Handrails and the Console Base. After you have started
all four Screws, tighten the Screws until they are
snug; do not overtighten the Screws.
Firmly tighten, but do not overtighten, the bolts used
in steps 2 through 4.
Insert the Wire Harness (53) through the two indicated
plastic ties on the Console Base (87) and up through the
hole in the Console Base.
3. Insert a Plastic Shim (9) into each side of the post on
the right side of the Base (38). Next, hold the Right
Upright (15) so the lower end is turned as shown, and
insert it into the Base. Make sure that the Wire
Harness (53) does not fall into the top of the Right
Upright. Be careful to avoid pinching the Wire
Harness. Note: If necessary, tap the Right Upright with
a rubber mallet until it is fully seated in the Base. If the
Right Upright cannot be fully seated, remove the outer
Plastic Shim and then insert the Right Upright.
Attach the Right Upright (15) to the Base (38) with three
1” Bolts (16) and three Star Washers (2). Do not tight-
en the Bolts yet.
Assemble the Left Upright (not shown) in the same
way.
15
Orient the
Upright as
shown.
53
9
16
2
3
2
38
16