Filter
Top Products
7
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
8. Attach the Storage Latch (14) to the left Upright (76) with
two 3/4” Screws (13). Be careful not to overtighten the
Screws.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 11), but do not
latch it. Make sure that the frame is centered between
the Handrails (1, 47 [not shown]). Firmly tighten all of
the bolts and screws used in assembly steps 3, 4,
and 5. Then, lower the frame to the floor.
13
14
1
76
Ties
47
62
6
1
10
46
21
6. Place the Console Base (46) on the Right Handrail (47)
and the Left Handrail (not shown). Touch the Right
Upright (62) to discharge any static.
Hold the Console (10) near the Console Base (46). Insert
the Wire Harness (21) through the two indicated plastic
ties on the Console Base. Next, insert the Wire Harness
up through the indicated opening in the Console Base
and through the plastic tie on the bottom of the Console.
Plug the widest connector on the Wire Harness (21) into
the widest connector on the Console (10). If the connec-
tor does not fit easily, rotate it and then connect it.
Plug the other connector on the Wire Harness into the
other connector on the Console. Note: The locations of
the connectors are shown by arrows.
Securely tighten the plastic tie on the Console (10) to
prevent the Wire Harness (21) from slipping. Then, cut
off the end of the plastic tie.
7. Set the Console (10) in the Console Base (46). Be careful
to avoid pinching any wires. Insert the excess Wire
Harness (21) into the large hole in the side of the Right
Handrail (47). Securely tighten the plastic ties on the
bottom of the Console Base to prevent the Wire
Harness from slipping. Cut off the ends of the plastic ties.
Attach the Console (10) to the Console Base (46) with
seven 3/4” Screws (13). Make sure that no wires are
pinched. Start all seven Screws before tightening
them; do not overtighten the Screws.
Attach the Console Base (46) to the Left and Right
Handrails (1, 47) with four 3/4” Screws (13).
7
8
21
21
Tie
46
10
13
13
13
47
Ties