Filter
Top Products
6
5. Identify the Right Handrail (47), which has a large hole in
the left side. Feed the Wire Harness (21) up into the rec-
tangular bracket on the Right Handrail and out the large
hole in the left side. Note: It may be helpful to use
needlenose pliers to pull the Wire Harness out of the
large hole.
Remove any plastic ties that are in the rectangular
bracket on the Right Handrail (47). Insert the bracket into
the top of the Right Upright (62). Attach the upper and
lower ends of the Right Handrail to the Right Upright with
two 1” Bolts (8). Do not tighten the Bolts yet.
Attach the Left Handrail (1) as described above. Note:
There is not a wire harness on the left side.
Attach the end of the ground wire to the small hole in the
side of the Right Handrail (47) with a Silver Ground
Screw (96).
4. Hold the Crossbar (34) between the Uprights (62, 76).
Attach the Crossbar with two 2 1/2” Bolts (53) and two
5/16” Washers (57). Do not tighten the Bolts yet.
3. Insert a Plastic Shim (97) into each side of the post on
the right side of the Base (11). Next, orient the Right
Upright (62) as shown, and insert it into the Base. Make
sure that the Wire Harness (21) does not fall into the
Right Upright. Be careful to avoid pinching the Wire
Harness. Note: If necessary, tap the Right Upright with a
rubber mallet until it is fully seated in the Base. If the
Right Upright cannot be fully seated, remove the outer
Plastic Shim and then insert the Right Upright.
Attach the Right Upright (62) to the Base (11) with three
1” Bolts (8) and three Star Washers (9). Do not tighten
the Bolts yet.
Assemble the Left Upright (not shown) in the same way.
Large
Hole
Bracket
47
76
1
62
21
62
This hole
must be
on this side.
21
97
8
9
34
53
57
Ground
Wire
53
57
76
62
3
5
4
9
96
11
8
8
8
8
8