Filter
Top Products
11. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 16). To protect the floor or carpet,
place a mat under the treadmill.
10. Raise the Frame (51) to the storage position
(see HOW TO FOLD THE TREADMILL FOR
STORAGE on page 13). Attach an Incline Leg
(69) to the Frame (51) with an Incline Leg Bolt
(32), two Incline Leg Washers (43), and an
Incline Leg Nut (46) as shown.
Repeat this step on the other side of the
Frame (51).
Adjust the Incline Legs (69) to the desired level
(see HOW TO CHANGE THE INCLINE OF THE
TREADMILL on page 12
).
10
46
43
43
32
51
69
8. Carefully lower the Left and Right Handrails (22,
33) until they are touching the floor.
See the lower drawing. Position the Uprights (53,
5
4) so that the treadmill Frame (51) is centered
between the Uprights.
Firmly tighten the four Handrail Bolts (2) and the
two Frame Pivot Bolts (1) used in steps 1 and 3.
Be careful not to overtighten the Frame Pivot
Bolts.
8
2
51
22, 33
1
53
51
54
Top View
9
9. Attach the Latch Housing (48) to the Left Upright
(53) with two Latch Screws (7); start both Latch
Screws before tightening them. Make sure
that the large hole in the Latch Housing is on
the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
7
Pin
Spring
Collar
Knob
48
53
Large Hole
9