Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver and two adjustable wrenches .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. Note that the right handrail and the console base
(not shown) are connected to the treadmill by a wire
harness. During assembly steps 1 to 3, be careful
not to pull on or damage the wire harness.
With the help of a second person, carefully lay the
treadmill on its side. Position one of the Base Legs
(62) on the base of the Upright (46) as shown. Make
sure that the Base Leg Pads (63) and the Wheel (68)
are in the indicated positions. Attach the Base Leg
with two silver Base Leg Bolts (65), two silver Base
Leg Washers (66), and two Base Leg Nuts (61).
Carefully turn the treadmill onto its other side.
Assemble the other Base Leg (62) as described.
With the help of a second person, carefully raise the
treadmill to the upright position so that both Base
Legs (62) are resting flat on the floor.
5
65
66
63
62
68
46
61
Screw (2)–2
Handrail Washer
(43) (Black)–4
Console Screw (11)–4
Upright Bolt (42) (Black)–4
Base Leg Nut (61) (Silver)–4
Handrail Star Washer (44)–4
Base Leg Bolt (65) (Silver)–4
Base Leg Washer
(66) (Silver)–4
1