Filter
Top Products
8
DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control
Monitor Display
BATTERY INSTALLATION
The console requires two "AA" batteries (not in-
cluded). Alkaline batteries are recommended. To in-
stall batteries, first touch the Handrail (2) to dis-
charge any static electricity. Next, open the battery
cover as shown below. Press two batteries into the
battery compartment, with the negative (Ð) ends of the
batteries touching the springs. Close the battery
cover, push up on the tab, and then push the tab for-
ward as shown. Be sure that the tab locks into place.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.) If there is a
thin sheet of clear plastic on the console, remove it.
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above) and
slide the clip onto your waistband.
CAUTION: Before operating the
console, read the following precautions.
¥ Do not stand on the walking belt when turn-
ing on the power.
¥ Always wear the clip (see the drawing above)
while operating the treadmill. When the key
is removed from the console, the walking
belt will stop.
¥ Adjust the speed in small increments.
¥ The training zones marked around the speed
control are general guidelines only. See page
14 or more information.
¥ To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable water
bottle.
Batteries
2
Battery Cover
Battery
Cover Tab