Filter
Top Products
26
Bracket
Plastic Tie
57
14
3
6
15
15
16
16
14
57
4
55
6
55
2
57
5
3. With the help of a second person, hold the Console Base
(6) and the Right Handrail (57) near the right Upright (14)
as shown. Insert all excess Wire Harness (26) into the
Handrail and down into the right Upright. Bend the Wire
Harness as shown, if necessary.
Cut the plastic tie holding the cage nut in the Handrail (57).
Next, make sure that the Wire Harness (26) is inside of
the bracket on the Right Handrail (57) and insert the
bracket into the right Upright (14). Make sure that the
Wire Harness is not pinched.
4. Position the Right Handrail (57) on the right Upright (14).
Attach the lower end of the Right Handrail first.
Thread a Handrail Bolt (15) with a Handrail Washer (16)
into the lower end of the Right Handrail and the right
Upright. Do not tighten the Handrail Bolt yet.
Attach the upper end of the Right Handrail (57) to the
right Upright (14) with a Handrail Bolt (15) and a Handrail
Washer (16). Do not tighten the Handrail Bolt yet.
5. Attach the Console Base (6) to the Left and Right
Handrails (2, 57) with four 3/4Ó Screws (55).
55 (Back out)
55
55
6
88
88
61
61
10
58
6
6. Back out the three indicated 3/4Ó Screws (55) from the
Console Base (6). Align the holes in the Weight Rack
(58) with the holes in the Console Base. Attach the
Weight Rack with seven 3/4Ó Screws (55) as shown. Be
careful not to overtighten the Screws.
Put the two 1-lb. Weights (88) into the outside slots in the
Weight Rack (58), the two 2-lb. Weights (61) into the next
slots, and the 3-lb. Weights (10) into the inside slots.
47
70
51
55
7
7. Attach the Catch (51) and the Catch Spacer (47) to the
left side of the Frame (70) with two 3/4Ó Screws (55). Be
careful not to overtighten the Screws.
8. Make sure that all parts are tightened before you use
the treadmill. Keep the included allen wrench in a se-
cure place. The allen wrench is used to adjust the walk-
ing belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
6