Filter
Top Products
11
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turning
on the power.
• Always wear the clip (see the drawing below)
while using the treadmill. When the key is
removed from the console, the walking belt will
stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids on
the console. Put only sealable water bottles in
the water bottle holders.
BATTERY INSTALLATION
The console
requires two
“AA” batteries
(not included).
Alkaline batter-
ies are recom-
mended. To
install batteries,
open the bat-
tery cover
beneath the
console as
shown. Press
two batteries
into the con-
sole. Make sure that the negative (–) ends of the
batteries are touching the springs. Close the battery
cover, push up on the tab, and then push the tab for-
ward as shown in the inset drawing. Make sure that the
tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 10).
Step onto the
foot rails of the
treadmill. Find
the clip attached
to the key, and
slide the clip
onto the waist-
band of your
clothes. Next,
insert the key
fully into the con-
sole. Test the clip by carefully taking a few steps
backward until the key is pulled from the console.
If the key is not pulled from the console, adjust
the position of the clip as needed.
DIAGRAM OF THE CONSOLE
Speed Control
Displays
Note: If there is a sheet of clear plastic on
the face of the console, remove it before
operating the console.
Clip
Key
Tab
Battery Cover
Battery Cover
Batteries