Filter
Top Products
7
65
1
Boss
Boss
Battery
Access
16
4
22
6
8. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the
included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To
protect the floor or carpet, place a mat under the treadmill.
6. Hold the Console (1) near the Console Plate (4). Touch
the Handrail (16) to discharge any static.
Locate the two wires in the Wire Harness (22) that have
L-shaped connectors on the ends. Press the connectors
onto the two tabs on the switch shown in inset drawing
6a. Connect the other two wires in the Wire Harness to
the back of the Console (1) in the locations shown by the
arrows in drawing 6. If the connectors do not fit to-
gether easily, rotate them and then connect them.
Set the Console (1) on the Console Plate (4).
IMPORTANT: Keep the Wire Harness (22) away from
the battery access opening and the bosses shown
above. Make sure that no wires are pinched before
you attach the Console (1) to the Console Plate (4).
Finger tighten the five 3/4” Screws (65) into the Console
Plate (4) and the Console (1). IMPORTANT: Make sure
no wires are damaged by the Screws. After all five
Screws have been started, firmly tighten them.
6a
Tabs
14
15
28
29
7
7. Attach a Wheel (15) to each side of the Base (28) with a
Wheel Bolt (14) and a Nut (29).