Filter
Top Products
6
77
78
55
5
6
Batteries
8
16
7
7. The console requires two "AA" batteries (not included).
Alkaline batteries are recommended. To install batteries,
first touch the Handrail (16) to discharge any static.
Next, open the Battery Cover (8). Press the batteries into
the battery compartment, with the negative (Ð) ends of
the batteries touching the springs. Close the battery
cover, push up on the tab, and then push the tab forward
as shown in the inset drawing. Be sure that the tab locks
into place.
6. Make sure that the Latch Pin (78) is in the Storage Latch
(77) as shown.
Attach the Storage Latch (77) to the Frame (55) with the
three Screws (5). Do not tighten the Screws yet.
Position the Storage Latch so that the Latch Pin (78) is
aligned with the hole in the left Upright (6). Slide the
Latch Pin into the hole as shown in the inset drawing.
Then, tighten the three Screws.
5
5. Important: You must be able to safely lift 45 pounds
(20 kg) in order to do this step.
Hold the treadmill with your hands in the locations
shown. Caution: To decrease the possibility of injury,
bend your legs and keep your back straight. As you
raise the treadmill, make sure to lift with your legs
rather than your back. Raise the treadmill to the vertical
position.
8. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet,
place a mat under the treadmill.
77
6
Battery
Cover Tab
Hole
78
4. Insert an Extension Leg (33) into the base of the right
Upright (6). Using the allen wrench, attach the Extension
Leg with an Extension Leg Screw (17). Make sure to push
down on the Extension Leg Screw while tightening it.
Attach the other Extension Leg (not shown) to the base of
the left Upright (not shown) in the same way.
4
17
33
6