Filter
Top Products
6
4. Position the Frame (41) between the Left and
Right Uprights (3, 9). Attach the Frame to the
U
prights with two M12 x 60mm Screws (11) and
two 12mm Washers (12).
Connect the Upright Wire (46) in the Left Upright
(3) to the wire from the Reed Switch (23).
See step 2. Tighten the four M10 Nuts (18)
used in step 2.
41
11
3
9
12
23
46
11
18
12
5. The Console (10) requires one “AA” battery (not
included); an alkaline battery is recommended.
Remove the battery cover (not shown) and insert
a battery;
make sure that the negative (–) end
of the battery is touching the spring in the
Console. Then, reattach the battery cover.
Slide the Console (10) onto the bracket in the
center of the Handrail (5).
Connect the Handrail Wire (49) to the console
wire. Then, insert the excess wiring into the
Handrail (5) and press the Grommet (48) into
the hole in the Handrail.
5
“AA”
Battery
10
Bracket
49
48
5
4
6. Remove the knob from the pin. Insert the pin,
with the spring, into the Latch Assembly (7) as
shown.
Then, tighten the knob onto the pin.
7
Pin
Spring
Knob
6