Filter
Top Products
6
7. Attach the Seat (12) to the Seat Post (5) with four M8
Split Washers (42) and four M8 Nylon Locknuts (10).
Note: The Split Washers and Nylon Locknuts may be
preattached to the underside of the Seat.
7
42
12
42
10
10
5
6
42
34
43
19
45
1
13
34
42
Console Wire
6. While another person holds the Upright (13) in the
position shown, connect the console wire to the Reed
Switch Wire (43). Next, connect the Resistance Cable
(19) to the Lower Cable (45) in the following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (45), and insert the tip of the Resistance
Cable (19) into the wire clip inside the metal bracket
as shown.
• See drawing B. Firmly pull up the Resistance Cable
(19) and slide it into the top of the metal bracket as
shown.
• See drawing C. Using pliers, squeeze the prongs on
the upper end of the metal bracket together.
Push the excess Cable (19, 45) and the excess console
wire down into the Frame (1), and insert the Upright into
the Frame. Be careful to avoid pinching the Wires
and Cables. Attach the Upright to the Frame with
three M8 x 15mm Button Screws (34) and three M8
Split Washers (42).
A
B
C
45
19
19
Metal
Bracket
Metal
Bracket
45
Be careful to
avoid pinching
the wires and
cables while
inserting the
Upright.