Filter
Top Products
6
29
1
2
2
2. Loosen the Frame Knob (29) on the right side of the
Frame (1). Slide out the Seat Frame (2) until it
stops. Tighten the Frame Knob.
1. Carefully slide the Handlebar Post (3) onto the
Frame (1) while pulling the excess Reed Switch
Wire (42) and Resistance Cable (31) up through the
Handlebar Post. Attach the Handlebar Post with
three M10 x 25mm Button Head Screws (53) and
three M10 Split Washers (54). Be careful not to
pinch the Reed Switch Wire or the Resistance
Cable.
1
3
54
54
53
53
31
42
4
3
42
10
33
32
43
43
4. Connect the Reed Switch Wire (42) to the console
wire. Next, attach the Console (33) to the Handlebar
Post (3) with four M4 x 16mm Screws (43). Press
the Resistance Knob (32) onto the Resistance
Control (10). Make sure that the mark on the
Resistance Knob is correctly aligned.
3. The Console (33) requires two ÒAAÓ batteries (not
included); alkaline batteries are recommended.
Open the battery door on the back of the Console.
Press two batteries into the Console. Make sure
that the negative (Ð) ends of the batteries are
touching the springs. Close the battery door.
53
3
Back of
Console
Console
Wire
Battery Door
Batteries
33
1