Weslo WLEX14000 Home Gym User Manual


 
11
Inspect and tighten all parts of the exercise cycle reg-
ularly. The exercise cycle can be cleaned with a soft,
damp cloth. To prevent damage to the console, keep
liquids away from the console and keep the console
out of direct sunlight.
CRANK ADJUSTMENT
If the arms of the
Crank (8) become
loose, they should
be tightened in
order to prevent
excessive wear.
Loosen the Hex
Crank Nuts (14)
on the left arm of
the Crank. Place
the tip of a stan-
dard screwdriver in one of the slots in the slotted
crank nut. Tap the screwdriver with a hammer to turn
the slotted crank nut counterclockwise until the arms
are no longer loose. Do not overtighten the slotted
crank nut. When the slotted crank nut is properly
tightened, tighten the Hex Crank Nuts.
HOW TO ADJUST THE REED SWITCH
If the console
does not dis-
play correct
feedback, the
reed switch
may need to
be adjusted.
To adjust the
reed switch,
you must first
remove the
Left Side
Shield (20).
Using an
adjustable wrench, turn the Left Pedal (39) clockwise
and remove it. Next, remove the indicated M4 x 12mm
Screws (5) and M4 x 38mm Self-tapping Screws (13).
Grip both Side Shields and gently pull them apart.
Turn the left arm of the Crank (8) to the position
shown, and carefully slide the Left Side Shield forward
and remove it.
With the left side shield removed, locate the Reed
Switch (42) (see the drawing below). Turn the Crank
(8) until the Magnet (61) is aligned with the Reed
Switch. Loosen but do not remove the M4 x 16mm
Screw (43). Slide the Reed Switch slightly closer to or
farther away from the Magnet. Retighten the Screw.
Turn the Crank for a moment. Repeat until the con-
sole displays correct feedback. When the Reed
Switch is correctly adjusted, reattach the left side
shield and the left pedal.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 3 on page 6.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
MAINTENANCE AND STORAGE
14
Slotted
Crank Nut
8
42
61
43
8
5
20
39
13
13
13
8
Front
View
Make sure that your thumb is positioned as shown,
and that you are applying the proper amount of
pressure to the pulse sensor. Try the sensor several
times until you become familiar with it.
5. To turn off the power, wait for about four minutes.
Note: The monitor has an Òauto-offÓ feature. If
the pedals are not moved and the console but-
tons are not pressed for four minutes, the
power will turn off automatically in order to
conserve the batteries.