Filter
Top Products
7
4. Connect the Reed Switch Wire (3) to the Extension
Wire (15).
Slide the Upright (2) onto the Frame (1); be careful
not to pinch the Reed Switch Wire (3), the
Extension Wire (15), or the Resistance Cable (17).
Attach the Upright with three M10 x 25mm Button
Head Screws (25) and three Split Washers (69).
5. Attach the Upright Bracket (26) to the Upright (2) with
two M6 x 1Ó Hex Head Screws (27) and two 1/4Ó Split
Washers (62). The square hole must be on the left side.
Push the Handlebar Caps (28) onto the lower ends of
the Handlebars (10, 11). Align the indicated holes and
make sure that the frictions pads are on the side
shown. See drawing 5a. Apply a thin film of grease to
both sides of the Handlebar Caps.
Hold the lower end of the Left Handlebar (10) inside
of the Upright Bracket (26). Insert the M10 x 150mm
Carriage Bolt (32) into the Upright Bracket and
through the Left Handlebar. Be careful not to dam-
age the wires inside the Upright. Hold the Right
Handlebar (11) inside of the Upright Bracket. Insert
the Carriage Bolt until the head of the Carriage Bolt is
in the square hole in the Upright Bracket. Slide the
Star Washer (29) onto the Carriage Bolt and tighten
the Resistance Knob (30) onto the Carriage Bolt.
See drawing 5b. Align the holes in the Handlebars (10,
11) with the hole in the Upright (2). Insert the Lock Pin
(31) through the Handlebars and the Upright. Be care-
ful not to damage the wires inside the Upright.
5
27
62
26
32
2
28
Holes
Holes
Friction
Pad
Friction
Pad
29
11
30
10
4
1
17
25
25
69
69
2
15
3
31
2
10
11
6. Connect the console wire to the Extension Wire (15).
Insert the Extension Wire and the console wire into
the Upright (2). Attach the Console to the Upright with
four Console Screws (33).
6
13
Console
Wire
33
2
33
15
28
5b
5a
28
Grease