Filter
Top Products
DESCRIPTIONOFTHECONSOLE HOWTOOPERATETHECONSOLE
Theconsoleisdesignedtohelpyougetthemost
fromyourworkouts.Asyouexercise,youcanwatch
yourprogressaroundtheLEDtrack,whilethe
displayprovidescontinuousexercisefeedback.
Thesixmodesof thedisplayaredescribedbelow.
000@000
I
o -- o
Speed--This mode displays your current exercise
speed, in miles per hour.
Time--This mode displays the length of time you
have exercised. Note: If you stop exercising, the time
mode will pause until you resume.
Distance--This mode displays the total distance you
have completed, in miles.
Laps--This mode displays the number of 1/4-mile
laps you have completed around the LED track.
Calorie--This mode displays the approximate number
of Calories you have burned.
Scan--This mode displays the speed, time, distance,
laps, and calorie modes, for 5 seconds each, in a
repeating cycle.
BATTERY INSTALLATION
Before the console can be operated, two "AA" batter-
ies must be installed. If you have not installed batter-
ies, see assembly step 10 on page 8.
If there is a thin sheet of clear plastic on the face of
the console, remove it.
To turn on the power, press the on/reset button or
simply begin exercising. When the power is turned
on, one LED indicator will light in the LED track,
and the entire display will appear for two seconds.
The console will then be ready for operation.
2. Select one of the five modes:
Scan mode--
When the power
is turned on, the
scan mode will
automatically be
selected. One
mode indicator
will show that the
SCAN CAL. LAPS
TI --I.I I n--I
II'OO
SPe_D TIME DIST.
Mode Indicators
scan mode is selected, and a flashing mode indica-
tor will show which mode is currently displayed.
Note: If a different mode is selected, you can
select the scan mode again by repeatedly pressing
the mode button.
Speed, time,
distance, laps,
or calorie mode--
To select one of
these modes for
continuous
display, press the
/
SCAN CAL, LAPS
t"7 1
i 13
SPffffD TIMff DIST.
mode button repeatedly. The mode indicators will
show which mode is selected. (Make sure that the
scan mode is not selected.)
The LED track represents a distance of 1/4 mile. As
you exercise, the indicators around the track will
light one at a time until you have completed 1/4
mile. A new lap will then begin.
4. To reset the display, press the on/reset button.
To turn off the power, simply wait for about four
minutes. Note: The console has an "auto-off"
feature. If the pedals are not moved and the
console buttons are not pressed for four
minutes, the power will turn off automatically
in order to conserve the batteries.
10