Filter
Top Products
7
6
14
31
8
28
45
17
15
A
1
2
20
21
23
30
21
53
53
19
29
4
5
4. Attach the Handlebar (5) to the Handlebar Post (14)
with two M10 x 25mm Button Screws (8) and two
M10 Split Washers (31).
5. Press the Side Shield Cover (30) into the Right and
Left Side Shields (1, 2). Make sure the four Tabs (A)
on the Side Shield Cover are securely fastened to
the Side Shields.
Insert the Seat Post (20) into the Frame (15). Make
sure that the Seat Post Bushing (23) is fully seated
in the Frame. Align one of the holes in the Seat
Post with the hole in the Frame. Insert the Seat
Knob (29) into the Frame and the Seat Post, and
tighten the Seat Knob into the Frame. Make sure to
insert the Seat Knob through one of the holes in
the Seat Post; do not insert the Seat Knob under
the Seat Post.
Attach the Seat (19) to the Seat Post (20) with four
M8 Nylon Locknuts (21) and four M8 Split Washers
(53). Note: The Nylon Locknuts and Split Washers
may be pre-attached to the bottom of the Seat.
6. Identify the Left Pedal (28) (there is an “L” on the
Left Pedal for identification). Using an adjustable
wrench, tighten the Left Pedal counterclockwise into
the left arm of the Crank (17).
Tighten the Right Pedal (not shown) clockwise into
the right arm of the Crank (17).
Adjust the Left Pedal Strap (45) to the desired posi-
tion. Press the Pedal Strap onto the indicated
adjustment tab. Do the same with the Right Pedal
Strap (not shown).
5
Adjustment
Tab