Filter
Top Products
7
5. Turn the Pedal Covers (27) upside-down. Remove
the paper backing from the adhesive strips on the
bottoms of the Pedal Cover.
Center one Pedal Cover (27) on the lower end of
the Left Leg (3). Press the Pedal Cover firmly in
place.
Attach the other Pedal Cover (27) to the lower
end of the Right Leg (4) in the same manner.
8. Remove the two indicated 3/8Ó x 3/4Ó Screws (23)
from the Right Upright (2). Attach the Monitor
Bracket (45) to the Right Upright with the two
Screws. Note: If the Electronic Monitor (50) does
not operate properly, see HOW TO ADJUST THE
REED SWITCH on page 11.
6. If your Electronic Monitor (50) has a battery cover
(see figure 6), install batteries as described in this
step. If your Monitor does not have a battery
cover, see step 7 to install batteries. Note: Two
ÒAAÓ batteries (not included) are required. Alkaline
batteries are recommended.
Press the tab on the battery cover and remove
the battery cover. Insert two batteries into the
Electronic Monitor (50). Make sure that the bat-
teries are turned as shown. Replace the battery
cover.
7. Refer to figure 7a. Remove the two Console
Screws (48) from the Monitor Bracket (45) and
the Electronic Monitor (50). Lift the Monitor off the
Monitor Bracket. Be careful not to pull the Reed
Switch Wire (47).
Refer to figure 7b. Insert two batteries into the
back of the Electronic Monitor (50). Make sure
that the batteries are turned as shown.
Refer to figure 7a. Reattach the Electronic Monitor
(50) to the Monitor Bracket (45) with the two
Console Screws (48).
45
23
2
50
Fig. 8
Fig. 5
27
3
4
27
50
Battery Cover
Fig. 7a
48
45
47
50
50
Fig. 7b
Fig. 6