Filter
Top Products
5
3. Attach the Right Frame Section (6) to the Right
Upright (2) with a 3/8Ó Screw (42), a Plastic
Spacer (41), and a 3/8Ó Nylon Locknut (43). Do
not tighten the Nylon Locknut yet.
4. Slide the Hip Pad (28) onto the Left Frame
Section (5).
Slide the Left and Right Frame Sections (5, 6)
together. Make sure that the indicated hole is
accessible. If necessary, slide the Hip Pad (28) to
the side. Attach the Frame Sections with a #8 x
3/4Ó Screw (23). Do not tighten the Screw yet.
Attach the Left Frame Section (5) to the Left
Upright (1) with a 3/8Ó Screw (42), a Plastic
Spacer (41), and a 3/8Ó Nylon Locknut (43).
Tighten all parts used in steps 1, 3, and 4.
Slide the Hip Pad (28) so it is centered on the
Frame Sections (5, 6).
Fig. 3
Fig. 4
6
28
23
Hole
5
42
1
41
43
6
2
42
41
43
7
9
3
40
16
12
40
Pin
Pin
2. Refer to figure 2b. Slide a Finger Guard (54) onto
the pins on the Left Pivot Bracket (7). Note: The
Finger Guards may already be attached.
Find a Link Arm (11). Make sure that there is a
Bronze Bushing (16) in each end of the Link Arm.
Slide one end of the Link Arm onto the indicated
pin on the Left Pivot Bracket (7). Slide a Spacer
(12) onto the pin and tap a 3/8Ó Axle Cap (40) onto
the pin. Slide the other end of the Link Arm onto
the pin on the Rocker Arm (9). (Note: It may be
necessary to pivot the Rocker Arm and the Left Leg
[3] slightly.) Slide a 3/8Ó Flat Washer (39) onto the
pin and tap a 3/8Ó Axle Cap (40) onto the pin.
Attach the other Finger Guard and Link Arm (not
shown) in the same manner.
Fig. 2a
11
Fig. 2b
54
7
Pins
16
39